[Materiał]
Wały : stal nierdzewna
・Color : Aluminium (A2017)
[zawartość]
Wały osiowe
pinezka beta
Kołnierz L
Kolory odległości
Łożyska kulkowe NTN
Uszczelki przeciwpyłowe od Hondy
*Łożysko referencyjne znajduje się po prawej stronie karoserii (w kierunku montażu przekładni licznika), dlatego najpierw należy zamontować łożysko od prawej strony.
*Łożysko jest również częścią precyzyjną, dlatego należy użyć specjalnego narzędzia, np. przyrządu do montażu łożysk, aby je wcisnąć, a nie wkręcić.
*Ze względu na dużą zmienność APtrike, prosimy o sprawdzenie aktualnych wymiarów wciskanych przed demontażem i montażem.
*Proszę nasmarować wszystkie części podczas montażu.
*APtrikes nie posiada instrukcji serwisowej, więc nie ma zalecanego momentu dokręcania. Dla porównania, zalecane momenty dokręcania dla wałów osi w pojazdach z równoważnymi częściami wynoszą 60Nm - 70Nm.
*Po zamontowaniu należy regularnie sprawdzać, czy nie nastąpiło poluzowanie.
*Należy uważać, aby nie wcisnąć łożysk na siłę lub użyć niewłaściwego momentu dokręcania. Zestaw wału osi jest produktem specjalnym i nie jest objęty żadną gwarancją, z wyjątkiem pierwszego uszkodzenia przed montażem.
*Istnieje przypadek, w którym dochodzi do zmiany specyfikacji towaru przez producenta. Proszę zrozumieć.
[Material]
・Shaft: Stainless steel
・Color: Aluminum (A2017)
[Components]
・Axle shaft
・Beta Pin
・L collar
・Distance color
・NTN ball bearings
・Dust seal made by HONDA
*When installing the bearing, the reference bearing is located on the right side of the bike (in the direction of the meter gear installation), so please install the bearing from the right side first.
*Bearings are also precision parts, so please use a special tool such as a bearing installer to press-fit them in, rather than pounding them in.
*When disassembling and assembling APtrikes, please check the current dimensions of the press-fit carefully before installation, as there is a large margin of error between individual APtrikes.
*Please grease up each part when installing.
*There is no service manual for APtrikes, so there is no specified tightening torque.For reference, the recommended tightening torque for axle shafts of bikes using equivalent parts is 60N-m to 70N-m.
*After installation, periodically check for loosening.
*Please be careful not to press-fit bearings or make mistakes in tightening torque.The axle shaft kit is a product that requires special work, so there is no warranty except for the initial failure before installation.
*There may be changes in product specifications due to the manufacturer's reasons.