Obowiązkowa pozycja dla każdego, kto ma problemy z postawieniem na nogach serii Z1 / Z2 / KZ1000 !.
Skóra siedziska jest cięta w celu wykonania gąbki do siedzenia dla Slim & Slim, dzięki czemu nie ma zbędnego nadmiaru i żaden wzór siedziska nie będzie przesunięty w dół.
Jeśli usiądziesz na nim okrakiem, zobaczysz, że jest znacznie węższy niż NORMAL. Martwisz się o jazdę na motocyklu, jeśli nie jesteś pewien swojej pozycji?
Pozbądź się tych rzeczy i ciesz się Zs w pełni !.
Proszę podać inny zaczep montażowy dla Z1 (typ z pojedynczym prętem) i KZ1000 (Kształt litery U) ..
1. Spróbuj umieścić siedzisko Slim w miejscu, z którego usunąłeś siedzisko Normal.. Jeśli uda nam się to tam dostać bez żadnych problemów.
2. Przymocuj mocowanie siedzenia do przedniej i tylnej części wspornika ramy do otwierania na boki.
W tym momencie należy poluzować śruby mocujące i tymczasowo je zamontować.. Więc
→ Jeśli nie zamyka się prawidłowo, podnosi się lub uderza zbyt mocno w osłonę ogonową, może zajść potrzeba wyregulowania wysokości mocowania.
→ Jeśli instalacja przebiegła pomyślnie, zmień na 3.
3. Zainstaluj gumową poduszkę za siedzeniem.. Więc
→ Jeśli zauważysz problem, taki jak zniekształcone lub podniesione siedzisko po siadaniu, musisz wyregulować Gumową poduszkę.
Musisz dostosować wysokość i tak dalej, aby osiągnąć średnią.
→ Jeśli to nie jest problem, to wszystko !.
Zaczep typu Z1 / Z2 (typ z pojedynczym prętem) (widzieć zdjęcie) i w kształcie litery U dla serii KZ1000
It is a necessity for the person who has trouble with the footing in Z1 / Z2 / KZ1000 series.
The seat leather is cut for the molding of the Slim & Slim seat sponge, so there is no unnecessary excess or shifting of the seat pattern downwards.
When you ride on it, you can see that the width is much narrower than stock.If you don't feel comfortable with your feet, you won't feel comfortable riding the bike, will you?
Please solve these problems and enjoy Z to the fullest.
The mounting hitch for Z1 (single bar type) and KZ1000 series (U-shaped) are different, so please specify.
1. Please put the slim seat on the place where the stock seat was removed.If I can get it on without a problem
Install the seat fitting to the front and rear of the frame bracket for horizontal opening.
At this time, loosen the fitting mounting bolts and leave them temporarily installed.therefore
If there is a problem such as it doesn't close properly, it lifts up and closes, or it hits the tail cowl tightly, you need to adjust the height of the fitting.
If the installation is successful, go to step 3.
3. Please install the rubber cushion on the back of the seat.therefore
If the seat is distorted or lifted, the rubber cushion needs to be adjusted.
It is necessary to adjust the height so that it hits on average.
If there is no problem, you are done.