Very Good
It's more than a utility barIt's my intention to make the Handlebar area as simple as possible, but it seems to be the case that the Grom's The thin iron Pipe is not encouraging and looks shabby; it's a Large standing bar I'm also somewhat worried about the strength In fact, when I pick up the Gap while HardCornering, it is a little bit shaky I thought about replacing the Handlebar, especially to make it aluminum (a little more forward leaning) I don't have a suitable one (and it's easier to ride), though I'm worried about the strength if I don't make it a fat bar Clamp has to be changed, and I'm worried about handling Hose and Cable, so much for that I don't want to do it As far as I'm concerned, as long as it has the necessary strength, it doesn't matter if it's iron or not So, what do you think of this kind of Handlebar Brace? I've always thought it was a standard reinforcement method for Off cars
But, according to my trusted motorcycle shop, the It's just for decoration, you know, because a lot of people wear their phones and stuff Well, do it with a USB power supply, smartphone holder, etc I don't want to Of course I don't need ETC, and I don't want to use RAM-MOUNT's clamp type (not resident) It's very easy to use, and Navigation is rarely used Since you won't need it, you can only clamp to the Handlebar when you really need it, and You can only use the Smartphone Holder for that time Then, when I shoot driving videos with my GoPro, I like to have a place to clamp it There is also a method of clamping directly to the Handlebar, but the angle is quite high So it is somewhat difficult to adjust the position
So...I decided to put this Handlebar Brace on First of all, I only expected it to be an utility bar. 22mm thick type I didn't want to make it stronger or anything, but simply because it's the same thickness as the Handlebar The RAMClamp is easy to install
As a result, the parts that arrived were extremely heavy It's actually very heavy It's very difficult to adjust the angle of the clamps Clamps are not in between, so I have to loosen up Perfect rigid mount with 4 screws After fixing the bar, the position of Lever was returned
So when I ran after installing it, I was pleasantly surprised by the miscalculation As I mentioned above, I wasn't expecting it to function as a Handlebar Brace at all The feel has changed properly First of all, the vibration is reduced There may be an effect of the vibration absorbing Hand guard that I just installed the other day It's even less And yet, it feels like you're touching something extremely hard, and the front area is even more relaxed It was Example Brrrr There is no face White, I deliberately picked up the Gap with the front wheel many times, but I went over the stoner and It is
At best, it's nimble and at worst, restless, which is the fate of the front and rear 12-inches groms Front in particular is vulnerable to disturbances, and when you step on the Gap in the middle of Corner, it's quite unpleasant! It got better Of course, the Stem Stabilizer from OUTEX, which has already been addressed, and KOOD's Thanks to the ChromolyShaft, Front was already better for Large I'm not satisfied yet, and I've already decided to change Spring and Fork oil Parts have been ordered Brake will be strengthened in the future So, considering that the load on the Front will become even more The Handlebar Brace feels reassuring
At first, I only intended to add a utility bar, so it was a nice miscalculation Ta I mean, the product is properly named Handlebar Brace! So I think it will meet the expectations in that direction as well If it were just about strength, though, I think the thin one would be enoughView Detail