Baza farby
[Zawartość produktu]
Zbiornik stalowy (Z2 Cap Specification / AP Cap Cap specyfikacji)
FRP Pokrywa boczna w lewo / w prawo
FRP Tail Cowl
* Należy pamiętać, że przy montażu zbiornika należy wymienić gumę prowadnicy zbiornika po etapie końcowym i obróbkę strony głównej.
* Proszę użyć kurka paliwowego, czujnika paliwa z czujnikiem STD (OEM ZEPHYR 400).
* Godło sprzedawane jest osobno.
* Należy pamiętać, że następujące produkty są sprzedawane osobno.
Godło czołgu
Godło bocznej osłony
Przedni błotnik
Lampa tylna
* Wymaga przetwarzania w przypadku montażu lampy tylnej.
* Istnieją przypadki, w których wymaga to przetwarzania w zależności od pojazdu, gdy używany jest zestaw zewnętrzny typu Z2 dla ZEPHYR 400 i X.
* W odniesieniu do lokalizacji przetwarzania
Należy ustabilizować zamocowanie gumy prowadnicy zbiornika, wymieniając ją na gumowy prowadnik czołowy na etapie późnym lub obróbkę po stronie głównej nadwozia przy montażu w pojeździe w pobliżu początkowego typu 400.
Osłona tylna jest zamocowana tylko w 2 punktach na przedniej stronie (dół siedziska). Dlatego zaleca się, aby z tyłu jak najmocniej używać osłony ciernej, ponieważ spowoduje to stopniowe obniżanie się tylnej części i pęknięcie osłony.
paint basis
[Components]
・Steel tank (Z2 cap spec / AP airplane cap spec.)
・FRP side covers (right and left)
・FRP tail cowl
*When installing the tank, you will need to replace the tank guide rubber with the late model tank guide rubber and modify the body side.
*Please use the stock fuel cock and fuel gauge sensor of ZEPHYR400.
*Emblem sold separately
*The following items are sold separately.
・Tank emblem
・Side cover emblem
・Front fender
・Taillight
*Processing is required to install the tail lamp.
*When you use Z2 type exterior set for Zephyr 400 and x, modification may be required depending on the bike.
*About the processing part
・If you are using early model of 400, please replace the tank guide rubber with late model or modify the body to stabilize the fixation of the tank guide rubber.
・The tail cowl is fixed to the front side (under the seat) at two points only.Therefore, it is recommended to use the cowl with the support at the rear as much as possible, because the rear part of the cowl will gradually fall down and cause the cowl to crack.