- pasowania:
- KAWASAKI Z1000 (air-cooled) 72-78
- KAWASAKI Z1-R/Z1-RII 72-78
- KAWASAKI Z1 (900SUPER4) 72-78
- KAWASAKI Z1000 (air-cooled) 72-78
The raised edge prevents leakage.Czytaj więcej - pasowania:
- KAWASAKI Z1-R/Z1-RII 72-80
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z900 (KZ900) 72-80
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI Z2 (750RS/Z750FOUR) 72-80
- ...i więcej.
If you use it well, it will not leak oil as much as the OEM type rubber ones. if you degrease the BALI and apply the liquid gas well, and if you reuse it, you can use it almost permanently by removing...Czytaj więcej - pasowania:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...i więcej.
Oil leak from Tachometer port is a common disease of air cooled Z.If it starts leaking, replace it with this one.The installation is a little hard, so apply more silicon grease and make sure to put it...Czytaj więcej - pasowania:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...i więcej.
This Nut is well thought out. If it is an aggregate tube, it is possible to fasten it even if it is different Nut somehow, but it is impossible if it is a 4-pipe exhaust system, and this Nut becomes n...Czytaj więcej - pasowania:
- KAWASAKI Z1-R/Z1-RII 78-80
- KAWASAKI Z1-R/Z1-RII 78-80
- KAWASAKI Z1000 (air-cooled) 77-78
- KAWASAKI Z2 (750RS/Z750FOUR) 73-75
- KAWASAKI Z1 (900SUPER4) 72-75
- ...i więcej.
If you want just the Washer, OEM Parts are still available.Czytaj więcej - pasowania:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...i więcej.
Oil leak & Ntilde. from Tachometer extraction part;It took me a long time to remove it, but I was able to remove it safely in the end. It took me a while to remove it, but I was able to remove it with...Czytaj więcej - pasowania:
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z1000 MkII 79-80
- KAWASAKI Z1-R/Z1-RII Type 2
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI Z900 (KZ900) 72-80
- ...i więcej.
I bought this one because the sound came out of the No-Mal Tensioner, but Spring's Weak rebound? I removed the carburetor and this time, the sound became worse I tried to install it with Spacer, but t...Czytaj więcej - pasowania:
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z1000 MkII 79-80
- KAWASAKI Z1-R/Z1-RII Type 2
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI Z900 (KZ900) 72-80
- ...i więcej.
I bought this one because the Nomar Tensioner came out sounding, but as per Manual I installed it, but the spring rebound is weak? Notch did not extend and the sound became terrible instead This time ...Czytaj więcej - pasowania:
- KAWASAKI GPz1100 79-85
- KAWASAKI Z1-R/Z1-RII 79-85
- KAWASAKI Z1000 (air-cooled) 79-85
- KAWASAKI Z1000J 79-85
- KAWASAKI Z1000R 79-85
- ...i więcej.
I'm using it on my Kawasaki KZ1000JI removed the OEM air cleaner box as part of the Carburetor replacement, so the secondary Attached to gas reduction system to cancelellationThey are manufactured usi...Czytaj więcej - pasowania:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...i więcej.
if you want to install it on the z1r 2, the quantity of 2 plates for Release:The position of 1pc (upper side) interfered with Stud was bad and Screw could not be attached Because it had no choice, I d...Czytaj więcej - pasowania:
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z1000 MkII 79-80
- KAWASAKI Z1-R/Z1-RII Type 2
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI Z900 (KZ900) 72-80
- ...i więcej.
It was attached to ZEPHYR 750, but it was a rough sound that is the same as OEM even for the stronger Spring. As I was installing Notch, Bolt was shorter than OEM so half of Tap on Engine side licked ...Czytaj więcej - pasowania:
- KAWASAKI Z1000 (air-cooled) 72-78
- KAWASAKI Z1-R/Z1-RII 72-78
- KAWASAKI Z1 (900SUPER4) 72-78
- KAWASAKI Z1000 (air-cooled) 72-78
This gasket I like because it has a groove on the top side to help keep oil from seeping out. I still use a little rtv where the cam plugs are because it always seem to seep out there. The material is...Czytaj więcej - pasowania:
- KAWASAKI
- KAWASAKI Z1-R/Z1-RII Type 2
- KAWASAKI
- KAWASAKI Z1000 (air-cooled) (KZ)
- KAWASAKI
- ...i więcej.
I love this oring, its flexible and fits perfectly into the tunnel groove. Other orings i bought were to hard to stay put in the tunnel but his one conforms and stays put. It has a stronger rubber com...Czytaj więcej - pasowania:
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z1000 MkII 79-80
- KAWASAKI Z1-R/Z1-RII Type 2
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI Z900 (KZ900) 72-80
- ...i więcej.
Nice quality, sets the tension for the cam automatically. Comes with an extra spring and bolts plus spacer for extra sensitive tension.Czytaj więcej - pasowania:
- KAWASAKI Z1000 MkII 79-80
- KAWASAKI Z1-R/Z1-RII 79-80
When aligned with OEM, expensive & lack of items MK 2's acceleration Pump, PMC's OHKit firmly restored performance.I can not experience the use with a new article already, but I was able t...Czytaj więcej - pasowania:
- KAWASAKI Z1000 (air-cooled) 72-78
- KAWASAKI Z1-R/Z1-RII 72-78
- KAWASAKI Z1 (900SUPER4) 72-78
- KAWASAKI Z1000 (air-cooled) 72-78
OEM's Red Gasket does not feel like using Head cover, so I always use the Other Company Product.Vesra etc. Standard Type is a little cutter cutting recently I feel that accuracy is bad. Fairly Cam...Czytaj więcej - pasowania:
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z1000 MkII 79-80
- KAWASAKI Z1-R/Z1-RII Type 2
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI Z900 (KZ900) 72-80
- ...i więcej.
The construction is very good.I think that it would be better to increase the corresponding model.I have attached to ZEPHYR, but I use it without problems.Czytaj więcej - pasowania:
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z1000 MkII 79-80
- KAWASAKI Z1-R/Z1-RII Type 2
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI Z900 (KZ900) 72-80
- ...i więcej.
? 【What made you decide the purchase?】 Compared with OEM Product, I chose it with high practicality.? 【How was it actually used?】 Regularly no longer worry about Camshaft Chain.? 【Was it difficult to ...Czytaj więcej - pasowania:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...i więcej.
Oil leaked from the Tachometer port, so I replaced it with the PMC Tachometer port.Installation was easy as it can be exchanged with Hexagon Bolt.If Oil leaks it is recommended to replace it.Czytaj więcej - pasowania:
- KAWASAKI Z750FX
- KAWASAKI Z1 (900SUPER4) 72-
- KAWASAKI Z750 (air-cooled) D
- KAWASAKI Z750 (air-cooled)
- KAWASAKI Z750 (air-cooled) A
- ...i więcej.
It is more friendly to Motorcycle to change the good things of Cost performance at an early stage as shown here than to buy and use high!Recommendation,Czytaj więcej
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING